No announcement yet.

Jcb 801

  • Filter
  • Time
  • Show
Clear All
new posts

  • Jcb 801

    Hi, I have an early 90's JCB 801 with a slewing problem. the linkages are badly worn and operating the control levers only takes up the slack in the linkages. I was wondering whether anybody can give me advice on by-passing the spool channels for cab slew & arm slew with an individual dedicated spool, which I could fit on the bulkhead by my feet? Is that practical? If so any advice on what I should be looking to source? Thanks in advance for any help you might be able to give. Terry

  • #2
    Simplest fix would be take the slop out of the linkages . Not sure what ends are on your machine . Be either pins through a clevis , Or like a tie rod end . Replace them and you should be good to go .